ELECRAFT KRX3 Provozní pokyny Strana 38

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 52
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 37
38
Connect a 6” (15 cm) TMP cable to J5 on the KREF3 board (see Figure 49).
Connect a 6” (15 cm) TMP cable between J1 on the KREF3 board and J83 on the Aux KSYN3 board as
shown in Figure 49.
Check the position of both the SUBOUT and SUBIN interface boards to be sure they are still fully seated in
their corresponding connectors on the K3 RF board.
Check to ensure the battery cover is in place protecting the top of the battery from contact with the KRX3
enclosure (see Figure 44). The top edge of the battery is the positive terminal, and touching the enclosure during
installation will short-circuit the battery.
Hold the assembled KRX3 module directly over the K3 and attach the TMP cables to J82 and J85 on the
module as shown in Figure 49.
Figure 49. TMP Cable Connection Pictorial Diagram.
Zobrazit stránku 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 51 52

Komentáře k této Příručce

Žádné komentáře