ELECRAFT K3-Remote Uživatelský manuál

ELECRAFT K3-Remote (including K3/0) OWNER’S MANUAL Revision A, April 4, 2012 Copyright © 2012, Elecraft, Inc. All Rights Reserved

10 Configuring Your Network Router The network router used at the remote location must be configured for port forwarding as

11 2. Locate the port forwarding page. On the Linksys router, this is under Applications and Gaming. With other routers, li

12 Remote Site Setup 1. Apply power to the K3 and confirm that it has firmware version 4.47 or later installed. If not, upd

13 Local Site Setup Using a K3/0 Figure 10

14 Local Site Setup using a K3 (K3/10 or K3/100) The K3 must have firmware version 4.47 or later installed.

15 Operation When you press the POWER switch on the K3 or K3/0 front panel, you should hear a beep and see frequency data d

16 Customer Service and Support Technical Assistance You can send e-mail to [email protected] and we will respond quick

17 Appendix A – Cable Sets Cables Supplied with RR-1256 Units Power Supply, Quantity 1: DC Power Cable, Quantity 1: USB A

18 RRK0CBL Cable Set E980207, Quantity 1: E980210, Quantity 1: E980211, Quantity 1: E850511 , Quantity 1: RRK3CBL C

19 Appendix B – Cable Schematics Cables whose schematics are not shown here are wired straight through, pin to pin. E85051

2 Contents Introduction ...

3 Introduction On behalf of our entire design team, we’d like to thank you for choosing the Elecraft K3 Remote system. The K

4 What You Will Need To operate a K3 remotely through your local area network (LAN) without communicating over the internet,

5 Setup Guide If you want the units to communicate between your local and remote systems over the internet, you will need to

6 2. Connect your computer and power to one of the RR-1256 units (see Figure 1). Figure 1 3. Launch the Microbit Setup M

7 Figure 4 4. Click on the Setup tab to open the window shown in Figure 3. Figure 3 5. Click on the Get button to open

8 7. Disconnect the USB cable between and connect both the RR-1256 Local (Control) unit with the CW knob and the computer t

9 9. Check or enter the following data in the Radio Settings window. Note that some are selected using drop-down menus: Pro